Technology

Why is My Netgear EX3700 Extender Not Connecting to Router?

Is your Netgear EX3700 extender refusing to connect to the router? Well, you are not alone! Every third Netgear user is facing the same issue. But, fret not because we’ve got your back! In this article, we’ve mentioned some of the most effective tips that’ll help you fix the extender not connecting to the router issue in a flash! So, read on.

Fixed: Netgear EX3700 Extender Not Connecting to Router

  1. Check the Power Supply

Let’s start with the basics first. If your Netgear EX3700 extender is not receiving enough power supply from the wall socket, then it’s quite obvious why it’s refusing to connect to the router. Your extender might not be getting an adequate power supply because of a damaged wall socket. To fix the issue, either get your current wall socket fixed or plug your extender into a different one.

  1. Reduce the Distance Between the Devices

One of the major reasons why your Netgear EX3700 extender is not connecting to the WiFi router is because the distance between your devices is too much. Therefore, make sure that your WiFi devices are placed in close proximity. Now, check whether you are able to resolve the issue or not. If not, then continue reading.

  1. Check the Ethernet Connection

Another reason why you’re stuck with the Netgear EX3700 extender not connecting to the router issue is because of a faulty Ethernet cable. Thus, check whether the Ethernet cable connecting your devices is damaged or not. In case it is, then replaces it with a new one without thinking twice. Also, make sure that the Ethernet connection is finger-tight.

  1. Perform Netgear Firmware Update

Outdated firmware can also be a factor in why your extender is not connecting to the router. If your extender is outdated, then you might also face issues like, can’t access mywifiext.net login page, being unable to change the extender’s password, etc. So, it is recommended that you update the firmware of your Netgear EX3700 extender immediately! Wondering how to do that? If the answer is yes, then it is advised that you refer to the user manual for the guidelines.

  1. Stay Away from Electronic Devices

If the WiFi signals of your range extender are getting interrupted, that too might prevent your device from connecting to the router. To troubleshoot the issue, ensure that your Netgear extender is placed far from WiFi-interference devices. Such devices include cordless phones, washing machines, baby monitors, refrigerators, treadmills, televisions, microwave ovens, Bluetooth speakers, etc.

  1. Configure Your Router Properly

If the aforementioned steps didn’t help you resolve the issue, then that’s probably because your Netgear router is not configured properly. So, make sure that your WiFi router is fully installed. Then, try to connect the Netgear EX3700 extender to the router. Any luck? No? In that case, give the next hack a shot.

  1. Reset Your Netgear EX3700 Extender

If even after all the efforts you’ve made, your Netgear EX3700 extender is still not connecting to the router, then it’s time you perform factory default reset.

Walkthrough the following steps to restore your Netgear WiFi range extender to the default mode:

  • Find the Reset button located on your EX3700 extender.
  • Once found, hold and press the button using an oil pin.
  • You can use a toothpick or paper clip to press the Reset button.
  • Release the button after a minute or two.

After resetting your Netgear EX3700 extender, perform Netgear extender setup from scratch.

The Bottom Line

In order to perform a hassle-free Netgear EX3700 setup, your extender should connect to the WiFi router. If you are facing issues while trying to connect your extender to the router, then following the tips mentioned in this article will surely help you fix the problem.

Related Articles

Back to top button